acerca De Este Artículo
- case Type Atx Full Tower
- front Tempered Glass+aluminum
- side Tempered Glass
- m/b Type Eeb(35 5cm X 35 5cm)/ Atx/ Micro-atx
- internal 4 X 3 5″ Hdd(hot Swap) 11 X 2 5″ Ssd
flexibility For Any Configuration
hot Swappable Drives
for Replacement Or Addition Of Storage Without Shutting Down The System
spacious For Multiple And Bigger Components
(d) 471 X (w) 285 X (h) 513mm
easier Built Process
effortless Cable Management
seamlessly Supporting
e-atx Motherboards
extension Bar (optional) Enables Support For The ROG Dominus Extreme
rgb Lighting Synch
front Panel Addressable Rgb
built-in RGB Effect Controlled By The Front Panel M|c Buttons To Synch With The Motherboard, Switch To The 8th Mode
important Note: make Sure To Connect The 3-pin Header Of The Controller To The 3-pin Header On The Motherboard. Do not Connect It To The 4-pin Header Or Unrecoverable Damages Will Occur. |
exquisite Aluminum Exterior
i/o Ports Panel Front Panel Right Side Case Feet
effortless Assembly
push And Hold To Unlock The Top Panel
screw-free, Quick And Easy
upgraded Cooling Support
stronger Airflow Support For An Additional 120mm Fan At The Rear
enough Room For A Thick Radiator At The Bottom Even When Mounting Dual Gpu Or Vertical Gpu
multiple Type Of Ports To Satisfy Any Need
4 X Usb3.0 + 1 X Type C + M|c RGB Control Buttons
2 X Usb3.0 At Top And Bottom To Catter To Different Usage Scenarios
more Flexibility For Gpu Configuration
8 Slots To Support Dual Gpu Or Vertically Mount Gpu
supporting High-end Gpus Up To 169mm Tall
vertical Gpu Holder
(sold Separately)
optimized Storage Layout
interchangeable, More Options For Customisation Possibility
the Hot Swappable Drive Bays
offers Room For 4 Drives
4
6
3 Inside The Drive Panel Behind The Motherboard
3 On The Mounting Bracket Beside The Motherboard
each Section Is Replacable With 120mm Fans
o11d Distro-plate G1 Designed By Ekwb
multiple Inlet And Outlet Ports
simplifies The Water-cooling Build Process
argb Lighting Effect
come With A Powerful Ddc3.1 Pwm Water Pump
note:
in The Condition Of Using The Included Riser Cable (pcie3.0) Of The Vertical Gpu Kit With A Pcie 4.0 Motherboard And A Pcie 4.0 Gpu, Please Follow Bellow Steps To Set Up Your Bios To Make It Compatible.
- make Sure That Your Motherboard Bios Is The Latest Version. If Not, Recommend To Update To The Latest Version.
- install Your Gpu Directly To The Motherboard And Start.
- enter Your Bios, Set The Pcie Slot From “auto” To “gen 3”. (example Photo As Below, For More Please Read The Manual Of Your Motherboard)
- save Your Settings And Turn Off The System
- 5. Install The Pcie 3.0 Riser Cable To The Motherboard And The Gpu, The System Would Be Able To Work.
Valoraciones
There are no reviews yet